Stop-SbecInstance is accessible with the help of BootEventCollector module. To configure BootEventCollector, go through this link.
Synopsis
Stops the Setup and Boot Event Collector.
Description
The Stop-SbecInstance cmdlet stops an instance of the Setup and Boot Event Collector.
You must have the Builtin Administrator privilege to run this cmdlet.
Parameters
-CimSession
Runs the cmdlet on the remote computers through a remote session. Enter a session object, such as the output of a New-CimSession or Get-CimSession cmdlet or an array of these objects. The default is to run the cmdlet on the local computer. For more information, see About_CimSession.
| Type: | CimSession[] |
| Position: | Named |
| Default value: | None |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
-ComputerName
Specifies the name of the computers on which you want to perform the operation. You can specify a fully qualified domain name (FQDN), a NetBIOS name, or an IP address. For more information see Invoke-CimMethod on MSDN.
| Type: | String[] |
| Position: | Named |
| Default value: | None |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
-Direct
Stops the Setup and Boot Event Collector instance directly through the WMI/CIM interface. Specify this parameter to stop an instance of the Setup and Boot Event Collector that was started from a command prompt.
If multiple instances are running (including the service), specifying this parameter stops a random instance, because WMI connects to a random instance. Do not use this parameter with the service, because the service controller interprets it as a service failure and restarts it.
| Type: | SwitchParameter |
| Position: | Named |
| Default value: | None |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
-Force
With the Service parameter, this parameter acts as a pass-through parameter for Stop-Service, allowing the cmdlet to stop a service even if that service has dependent services. With Direct, requests the fast stopping, discarding the buffered but not yet fully processed data.
| Type: | SwitchParameter |
| Position: | Named |
| Default value: | None |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
-Service
Stops the Setup and Boot Event Collector service on the current computer.
| Type: | SwitchParameter |
| Position: | Named |
| Default value: | None |
| Accept pipeline input: | False |
| Accept wildcard characters: | False |
Syntax
Stop-SbecInstance [-Service] [-Force] [<CommonParameters>]
Stop-SbecInstance [-Direct] [-ComputerName <String[]>] [-CimSession <CimSession[]>] [-Force] [<CommonParameters>]
—————–Example 1—————–
Stop the Boot Event Collector service
PS C:\> Stop-SbecInstance -Service
This command stops the Boot Event Collector service.
—————–Example 2—————–
Stop a Boot Event Collector instance
PS C:\> Stop-SbecInstance -Direct
This command stops an instance of Boot Event Collector that was started from the command line.
—————–Example 3—————–
Immediately stop a Boot Event Collector instance
PS C:\> Stop-SbecInstance -Direct -Force
This command stops an instance of Boot Event Collector that was started from the command line, and discards any buffered but not-yet processed data.
You can check the Version, CommandType and Source of this cmdlet by giving below command.
Get-Command Stop-SbecInstance
You can also read about
- Get-SbecActiveConfig
- Save-SbecInstance
- Set-SbecActiveConfig
- Start-SbecInstance
- Test-SbecActiveConfig
To know more PowerShell cmdlets(Commands) on BootEventCollector click here